Trabajo Fin de Grado
Estimación de vida a fatiga en un eje con ajuste a presión
Autor/es | Montiel Polvillo, Mario |
Director | Navarro Pintado, Carlos |
Departamento | Universidad de Sevilla. Departamento de Ingeniería Mecánica y de Fabricación |
Fecha de publicación | 2017 |
Fecha de depósito | 2017-10-26 |
Titulación | Universidad de Sevilla, Grado en Ingeniería en Tecnologías Industriales |
Resumen | Este proyecto se centrará en el análisis de la unión con ajuste a presión, de la cual estableceremos unas
dimensiones de eje y agujero con las que trabajaremos durante el proyecto. Dividiremos el proyecto en dos
partes ... Este proyecto se centrará en el análisis de la unión con ajuste a presión, de la cual estableceremos unas dimensiones de eje y agujero con las que trabajaremos durante el proyecto. Dividiremos el proyecto en dos partes diferenciadas: la obtención de las tensiones producidas y la estimación de la vida a fatiga. Para la obtención de tensiones primero evaluaremos los resultados analíticos 2D y lo compararemos con los resultados obtenidos mediante un análisis con elementos finitos en ANSYS en 2D. Posteriormente, procederemos a hacer el análisis en ANSYS en 3D solo con el ajuste y después pasaremos a aplicar una fuerza que produzca la flexión del eje. Una vez obtenidas las tensiones para el caso con flexión, utilizaremos un criterio de fatiga multiaxial para la estimación del número de ciclo hasta el fallo de la pieza. This project will focus on the analysis of the interference fit, we will set the dimensions for the shaft and the hole we will work with. We can divide the project in two different parts: the extraction of stresses and ... This project will focus on the analysis of the interference fit, we will set the dimensions for the shaft and the hole we will work with. We can divide the project in two different parts: the extraction of stresses and the fatigue life estimation. For the extraction of stresses, we will first evaluate the 2D analytic results and compare with the 2D ANSYS finite element analysis. Later, we will make the 3D ANSYS analysis due to the press fit and when we are finished with that we will apply a force on the end of the shaft that will bend the shaft. Once we obtained the stresses for the bending shaft, we will apply a multiaxial fatigue criterion for the estimation of the number of cycles until the failure of the shaft. |
Cita | Montiel Polvillo, M. (2017). Estimación de vida a fatiga en un eje con ajuste a presión. (Trabajo Fin de Grado Inédito). Universidad de Sevilla, Sevilla. |
Ficheros | Tamaño | Formato | Ver | Descripción |
---|---|---|---|---|
TFG Mario Montiel Polvillo.pdf | 2.879Mb | [PDF] | Ver/ | |