Buscar
Mostrando ítems 1-10 de 13
Artículo
Effect of milling parameters on the development of a nanostructured FCC–TiNb15Mn alloy via high-energy ball milling
(MDPI AG, 2021)
In this work, a blend of Ti, Nb, and Mn powders, with a nominal composition of 15 wt.% of Mn, and balanced Ti and Nb wt.%, was selected to be mechanically alloyed by the following two alternative high-energy milling devices: ...
Ponencia
Amorfización de aleación Ti40 CU60 mediante molienda mecánica
(3 ciencias. Área de Innovación y Desarrollo,S.L., 2019)
En los últimos 10 años, las aleaciones cristalinas de Ti-Cu han sido estudiadas intensivamente por sus buenas propiedades mecánicas y protección contra corrosión. Una de las posibilidades para mejorar aún más estas ...
Artículo
Influence of Temperature on Mechanical Properties of AMCs
(MDPI, 2020-06)
This research focused on studying the effect of temperature on the mechanical properties of aluminium matrix composites (AMCs) obtained by a powder metallurgy route. Aluminium powder was milled at room temperature for 5 h ...
Artículo
Obtención y procesado de aleaciones de grano ultrafino, nanométrico y amorfas mediante aleado mecánico
(Centro nacional de Investigaciones Metalurgicas, 2007)
El Grupo de Metalurgia e Ingeniería de los Materiales de la Universidad de Sevilla ha desarrollado, durante los últimos quince años, diversas técnicas para la consolidación de aleaciones de aluminio obtenidas por aleado ...
Artículo
Mechanical alloying and amorphization of Ti75Cu25 alloy
(Elsevier, 2022)
Ti-Cu alloys are used in dental and medical applications, due to their good mechanical properties, corrosion resistance and antibacterial properties. These properties are sensitive to microstructure and can be improved by ...
Artículo
Amorphous Al-Ti Powders Prepared by Mechanical Alloying and Consolidated by Electrical Resistance Sintering
(MDPI, 2019-10)
A novel processing method for amorphous Al50Ti50 alloy, obtained by mechanical alloying and subsequently consolidated by electrical resistance sintering, has been investigated. The characterisation of the powders and the ...
Artículo
Consolidation by MF-ERS of mechanically alloyed Al powder
(Elsevier, 2019-07)
The aim of this work is to study the viability of producing, by medium-frequency electrical resistance sintering (MF-ERS), compacts from mechanically alloyed aluminium powders. The MF-ERS process was carried out using ...
Artículo
Development of a TiNbTaMoZr-Based High Entropy Alloy with Low Young´s Modulus by Mechanical Alloying Route
(MDPI, 2020-11)
In this work, an equiatomic TiNbTaMoZr-based high-entropy alloy (HEA) has been developed by a powder metallurgy route, which consists of a process of combined one-step low-temperature mechanical milling starting from the ...
Artículo
Synthesis and characterization of in situ-reinforced Al–AlN composites produced by mechanical alloying
(Elsevier, 2017)
This research is focused on the production of aluminum matrix composites (AMCs) reinforced with various percentages of aluminum nitride (AlN). For this purpose, aluminum powder was milled at room temperature for a total ...
Ponencia
Phase stability, porosity distribution and microstructural evolution of amorphous Al50Ti50 powders consolidated by electrical resistance sintering
(American Institute of Physics Inc., 2015-03)
The effect of intensity and duration of the electrical resistance sintering process on the phase stability, porosity distribution and microstructural evolution of Al50Ti50 amorphous powders is studied. The phase ...