Influence of temperature on the biaxial strength of cemented carbides with different microstructures
|Author/s||Chicardi Augusto, Ernesto
Gotor Martínez, Francisco José
Llanes Pitarch, Luis Miguel
Torres Hernández, Yadir
|Department||Universidad de Sevilla. Departamento de Ingeniería y Ciencia de los Materiales y del Transporte|
|Abstract||The effect of the temperature on the mechanical strength of WC-Co cemented carbides with different microstructures (grain size and binder content) was evaluated. Biaxial flexural tests were performed on three cemented ...
The effect of the temperature on the mechanical strength of WC-Co cemented carbides with different microstructures (grain size and binder content) was evaluated. Biaxial flexural tests were performed on three cemented carbide grades at 600 °C using the ball-on-three-balls (B3B) method. Results were interpreted by Weibull statistics and compared to biaxial strength results at room temperature. A detailed fractographic analysis, supported by Linear Elastic Fracture Mechanics, was performed to differentiate the nature and size of critical defects and the mechanism responsible for the fracture. A significant decrease in the mechanical strength (around 30%) was observed at 600 °C for all grades of cemented carbides. This fact was ascribed to the change in the critical flaw population from sub-surface (at room temperature) to surface defects, associated with the selective oxidation of Co. Additionally, an estimation of the fracture toughness at 600 °C was attempted for the three cemented carbides, based upon the B3B strength results, the corresponding number of the tested specimens fragments and the macroscopic area of the B3B fracture surfaces. The fracture toughness was not affected by the temperature, at least up to 600 °C. In addition, the good agreement with the Single Edge Notch Beam toughness data suggests the possibility of employing this approach for fracture toughness evaluation of brittle materials under different testing conditions.
|Citation||Chicardi Augusto, E., Bermejo, R., Gotor Martínez, F.J., Llanes Pitarch, L.M. y Torres Hernández, Y. (2018). Influence of temperature on the biaxial strength of cemented carbides with different microstructures. International Journal of Refractory Metals and Hard Materials, 71, 82 p.-91 p..|
|IJRMHM_Torres_2018_influence of.pdf||3.446Mb||[PDF]||View/||Artículo principal|