Buscar
Mostrando ítems 1-5 de 5
Artículo
Effect of milling parameters on the development of a nanostructured FCC–TiNb15Mn alloy via high-energy ball milling
(MDPI AG, 2021)
In this work, a blend of Ti, Nb, and Mn powders, with a nominal composition of 15 wt.% of Mn, and balanced Ti and Nb wt.%, was selected to be mechanically alloyed by the following two alternative high-energy milling devices: ...
Artículo
Influence of Temperature on Mechanical Properties of AMCs
(MDPI, 2020-06)
This research focused on studying the effect of temperature on the mechanical properties of aluminium matrix composites (AMCs) obtained by a powder metallurgy route. Aluminium powder was milled at room temperature for 5 h ...
Artículo
Mechanical alloying and amorphization of Ti75Cu25 alloy
(Elsevier, 2022)
Ti-Cu alloys are used in dental and medical applications, due to their good mechanical properties, corrosion resistance and antibacterial properties. These properties are sensitive to microstructure and can be improved by ...
Artículo
Development of a TiNbTaMoZr-Based High Entropy Alloy with Low Young´s Modulus by Mechanical Alloying Route
(MDPI, 2020-11)
In this work, an equiatomic TiNbTaMoZr-based high-entropy alloy (HEA) has been developed by a powder metallurgy route, which consists of a process of combined one-step low-temperature mechanical milling starting from the ...
Artículo
Amorphous Phase Formation and Heat Treating Evolution in Mechanically Alloyed Ti–Cu Alloy for Biomedical Applications
(Springer, 2022-12)
The present work aims to produce TixCu100-x (x=90, 80, 70, and 60) amorphous alloys by using high energy ball mill. The microstructure and possible formation of amorphous phases were characterized employing laser granulometry, ...