Buscar
Mostrando ítems 1-10 de 18
Artículo
Creep properties of high dense La9.33Si6O26 electrolyte for SOFCs
(Elsevier, 2020-05)
High density La9.33Si6O26 polycrystals were fabricated by conventional and spark plasma sintering starting from nanopowders synthesized by freeze-drying. The materials exhibit a homogeneous microstructure formed by equiaxed ...
Artículo
Metal-like peak stress behavior of yttrium-doped BaCeO3 ceramic
(Elsevier, 2022)
The high-temperature mechanical behavior of polycrystalline 5 at% yttrium-doped barium cerate with submicronic grain size (d = 0.5 µm) has been studied in compression between 1200 and 1300 °C at different initial strain ...
Artículo
Microstructural characteristics of TZP/Ni cermets plastically deformed at high temperature
(Elsevier, 2007)
The microstructure of 3 mol% Y2O3-stabilized tetragonal ZrO2/Ni (TZP/Ni) composites has been investigated for nickel concentrations of 20, 30 and 40 vol.% before and after creep tests conducted in argon atmosphere at 1250 ...
Artículo
High Temperature Compressive Strength and Creep Behavior of Si-Ti-C-O Fiber-Bonded Ceramics
(Elsevier, 2017)
Fiber bonded silicon carbide ceramic materials provide cost-advantage over traditional ceramic matrix composites and require fewer processing steps. Despite their interest in extreme environment thermostructural applications ...
Artículo
High-temperature mechanical behavior of proton-conducting yttrium-doped barium zirconate perovskite
(Elsevier, 2021-02)
The high-temperature mechanical properties of yttrium doped barium zirconate obtained by two different routes are reported in this work. Polycrystals with composition BaZr0.85Y0.15O2.925 have been fabricated from nanopowders ...
Artículo
Deformación plástica en compresión de Si3N4 policristalino: consideraciones sobre los modelos de solución-reprecipitación y de formación de cavidades
(2001)
La fluencia del nitruro de silicio se ha estudiado en varios materiales comerciales y experimentales. El rango de temperaturas ha sido 1.400-1.500 °C y, para evitar la degradación de las muestras, se usó atmósfera inerte. ...
Artículo
Cavitación durante la fluencia de policristales de Si3N4
(Sociedad Española de Cerámica y Vidrio, 2005)
Este trabajo está orientado a determinar las condiciones de tensión y temperatura para las cuales ocurre la nucleación y coalescencia de cavidades en dos materiales cerámicos a base de nitruro de silicio sinterizados bajo ...
Artículo
Fabrication, microstructure and high-temperature plastic deformation of three-phase Al2O3/Er3Al5O12/ZrO2 sintered ceramics
(Elsevier, 2021)
The fabrication, microstructure and high-temperature creep behavior of chemically compatible, three-phase alumina/erbium aluminum garnet (Er3Al5O12, EAG)/erbia fully-stabilized cubic ZrO2 (ESZ) particulate composites with ...
Artículo
Fluencia a alta temperatura de compuestos alúmina-circona
(1996)
Se ha estudiado la microestructura y la respuesta mecánica en compresión a alta temperatura de dos cerámicos de alúmina reforzada con circona (ZTA), fabricados mediante mezcla de polvos y mediante sol-gel con precursores ...
Artículo
Creep study on alumina and alumina/SWCNT nanocomposites
(Elsevier, 2018)
Alumina and alumina/SWCNT nanocomposites have been sintered by spark plasma sintering, obtaining relative densities higher than 99%. Microstuctural characterization revealed a grain microstructure in the submicron range, ...