Buscar
Mostrando ítems 1-10 de 13
Tesis Doctoral
Study of the stress state and failure in adhesive joints with composite materials.
(2012-04-16)
Con la creciente demanda de los materiales compuestos por parte de la industria, las uniones adhesivas se destacan como una atractiva alternativa frente a las tradicionales uniones mecánicas, que exigen como paso ...
Artículo
A time domain analysis of train induced vibrations
(Techno-Press, 2012)
This paper is intended to show the robustness and capabilities of a coupled Boundary Element-Finite Element technique for the analysis of vibrations generated by high-speed trains under different geometrical, mechanical ...
Ponencia
Experimental and Analytical Approach for the Assesment of Flexural Strength of Adobe Masonry
(Pontificia Universidad Católica del Perú, 2012)
This paper presents an investigation about the flexural behavior of adobe masonry. It is focused on the development of constitutive models that can serve as a basis for the establishment of new design guidelines for adobe ...
Artículo
Comportamiento dinámico de viaductos cortos considerando la interacción vehículo-vía-estructura-suelo
(Centro Internacional de Métodos Numéricos en Ingeniería (CIMNE) de la Universitat Politécnica de Catalunya (UPC), 2012)
En este artíıculo se estudia la influencia de la interacción dinámica vehículo-vía-estructura-suelo en el comportamiento de viaductos. Dicho anáalisis se lleva a cabo usando un modelo acoplado, formulado en el dominio del ...
Ponencia
Empirical flexural behaviour approach of adobe masonry
(Historical and Mansory Structures, 2012)
Adobe masonry is one of the most widespread low cost material used for housing in the world. Unfortunately, it shows very low mechanical strength and it is mainly used in seismic. Therefore, there is a requirement for ...
Tesis Doctoral
Study of the Behaviour of Non-Crimp Fabric Laminates by 3D Finite Element Model
(2012)
The aerospace industry is committed to improving the performance of aircraft whilst reducing emissions and weight. Part of this goal can be achieved with the use of new types of composite materials, such as non-crimp fabric ...
Tesis Doctoral
Análisis metodológico, diseño y cálculo de composites en la rehabilitación del patrimonio histórico arquitectónico del bajo Guadalquivir
(2012-12-05)
La utilización de los materiales compuestos, en la actualidad, está muy extendida en los diversos sectores industriales, y de hecho, en algunos de ellos, son ya imprescindibles, siendo esta tendencia ascendente, debido a ...
Artículo
Teaching Structural Analysis through design, building and testing
(ASCE, 2012)
This paper presents the results of an innovative teaching experience in the area of structural analysis in the mechanical engineering program of the Universidad de Sevilla, Spain. The teaching methodology used is aimed at ...
Artículo
Study of transversal and delamination cracks in [0/90] symmetric laminates by means of the linear elastic brittle interface formulation
(Grupo Español de Fractura, 2012)
En el presente trabajo se estudia el inicio y crecimiento de grietas transversales y de delaminación en laminados simétricos [0/90], bajo cargas de tracción en la dirección de las fibras en las láminas externas. El ...
Ponencia
La investigación en medioambiente
(Universidad de Sevilla, 2012)