Buscar
Mostrando ítems 1-10 de 33
Artículo
Thermal Arrest Analysis of the Reverse Martensitic Transformation in a Ni55Fe19Ga26 Heusler Alloy Obtained by Melt-spinning
(Springer Nature, 2023)
Ni55Fe19Ga26 ribbons obtained by melt-spinning technique exhibit a martensitic transformation from L21 cubic austenite phase to 14 M martensite phase above room temperature. We have taken advantage of the existence of ...
Artículo
Ball Milling of Fe83Zr6B10Cu1 Amorphous Alloy Containing Quenched in Crystals
(Elsevier, 2007)
A Fe83B10Zr6Cu1 melt-spun amorphous alloy has been ball milled in the presence of partially crystalline ribbon pieces, in order to speed up its mechanical nanocrystallization process. Microstructure and magnetic properties ...
Artículo
Extension of the Classical Theory of Crystallization to Non-isothermal Regimes: Application to Nanocrystallization Processes
(Elsevier, 2012)
The non-isothermal kinetics of primary crystallization processes is studied from numerically generated curves and their predictions have been tested in several nanocrystallization processes. Single processes and transformations ...
Artículo
A Direct Extension of the Avrami Equation to Describe the Non-isothermal Crystallization of Al-base Alloys
(Elsevier, 2007)
A direct extension of the Avrami equation considering the temperature dependence of the frequency factor is applied to describe the crystallization of a series of Al-Mm-Ni-Co amorphous alloys (Mm is a mischmetal). For high ...
Artículo
Specific Heat Measurements on Amorphous and Nanocrystalline Al88Y5Ni5Co2
(Elsevier, 2009)
Specific heat at constant pressure, CP, was measured on amorphous and nanocrystalline Al88Y5Ni5Co2 alloys from differential scanning calorimetry experiments. Linear behavior of CP versus temperature from 323 to 423 K is ...
Artículo
Enhancement of the Magnetic Refrigerant Capacity in Partially Amorphous Fe 70Zr 30 Powders Obtained by Mechanical Alloying
(Elsevier, 2012)
After mechanical alloying Fe 70Zr 30 composition from pure starting powders, an amorphous phase with Curie temperature T C = 244 K and an intermetallic compound (that should be non-stoichiometric Zr-rich fcc Fe 2Zr phase) ...
Artículo
Cellular automata simulations on nanocrystallization processes: From instantaneous growth approximation to limited growth
(Elsevier, 2011-07)
Cellular automata simulations have been performed to simulate the crystallization process under a limited growth approximation. This approximation resembles several characteristics exhibited by nanocrystalline microstructures ...
Artículo
Supersaturated Solid Solution Obtained by Mechanical Alloying of 75% Fe, 20% Ge and 5% Nb Mixture at Different Milling Intensities
(Elsevier, 2009)
Mechanical alloying process of Fe75Ge20Nb5 composition has been studied at different milling frequencies from initial pure powder mixture to the development of a single bcc phase (supersaturated solid solution). As an ...
Artículo
Thermal and Microstructural Dependence of the Initial Permeability of Co60Fe18Nb6(B,Cu)16 Alloys
(Elsevier, 2007)
The thermal and microstructural dependence of the initial permeability of Co60Fe18Nb6B16-yCuy (y = 0, 1) alloys have been studied. The comparison of kinetics and microstructural data of the two compositions indicate the ...
Artículo
Anisotropy field distribution in soft magnetic Hitperm alloys submitted to different field annealing processes
(Elsevier, 2016)
The magnetic anisotropy field distribution is discussed for Hitperm alloys annealed under different field conditions leading to different induced magnetic anisotropies: zero (ZF), transversal (TF), and longitudinal (LF) ...