Diseño de circuitos analógicos y de señal mixta con consideraciones de diseño físico y variabilidad
|Author||Toro Frías, Antonio|
|Director||Fernández Fernández, Francisco Vidal
Castro López, Rafael
|Department||Universidad de Sevilla. Departamento de Electrónica y Electromagnetísmo|
|Abstract||Advances in microelectronic technology has been based on an increasing capacity to integrate transistors, moving this industry to the nanoelectronics realm in recent years. Moore’s Law  has predicted (and somehow governed) ...
Advances in microelectronic technology has been based on an increasing capacity to integrate transistors, moving this industry to the nanoelectronics realm in recent years. Moore’s Law  has predicted (and somehow governed) the growth of the capacity to integrate transistors in a single IC. Nevertheless, while this capacity has grown steadily, the increasing number of design tasks that are involved in the creation of the integrated circuit and their complexity has led to a phenomenon known as the ``design gap´´. This is the difference between what can theoretically be integrated and what can practically be designed. Since the early 2000s, the International Technology Roadmap of Semiconductors (ITRS) reports, published by the Semiconductor Industry Association (SIA), alert about the necessity to limit the growth of the design cost by increasing the productivity of the designer to continue the semiconductor industry’s growth. Design automation arises as a key element to close this ”design gap”. In this sense, electronic design automation (EDA) tools have reached a level of maturity for digital circuits that is far behind the EDA tools that are made for analog circuit design automation. While digital circuits rely, in general, on two stable operation states (which brings inherent robustness against numerous imperfections and interferences, leading to few design constraints like area, speed or power consumption), analog signal processing, on the other hand, demands compliance with lots of constraints (e.g., matching, noise, robustness, ...). The triumph of digital CMOS circuits, thanks to their mentioned robustness, has, ultimately, facilitated the way that circuits can be processed by algorithms, abstraction levels and description languages, as well as how the design information traverse the hierarchical levels of a digital system. The field of analog design automation faces many more difficulties due to the many sources of perturbation, such as the well-know process variability, and the difficulty in treating these systematically, like digital tools can do. In this Thesis, different design flows are proposed, focusing on new design methodologies for analog circuits, thus, trying to close the ”gap” between digital and analog EDA tools. In this chapter, the most important sources for perturbations and their impact on the analog design process are discussed in Section 1.2. The traditional analog design flow is discussed in 1.3. Emerging design methodologies that try to reduce the ”design gap” are presented in Section 1.4 where the key concept of Pareto-Optimal Front (POF) is explained. This concept, brought from the field of economics, models the analog circuit performances into a set of solutions that show the optimal trade-offs among conflicting circuit performances (e.g. DC-gain and unity-gain frequency). Finally, the goals of this thesis are presented in Section 1.5.
|Citation||Toro Frías, A. (2017). Diseño de circuitos analógicos y de señal mixta con consideraciones de diseño físico y variabilidad. (Tesis Doctoral Inédita). Universidad de Sevilla, Sevilla.|