Buscar
Mostrando ítems 1-7 de 7
Artículo
Medium-Frequency Electrical Resistance Sintering of Soft Magnetic Powder Metallurgy Iron Parts
(MDPI, 2021-06)
The fabrication of soft magnetic Fe parts by the medium-frequency electrical resistance sintering (MF-ERS) technique is studied in this paper. This consolidation technique involves the simultaneous application to metallic ...
Artículo
Influence of Milling Atmosphere on the Controlled Formation of Ultrafine Dispersoids in Al-Based MMCs
(MDPI, 2016)
Properties of compacts made from aluminium powder, milled under different atmospheres, were evaluated. The duration of all the milling processes was 10 h, although different atmospheres were tested: vacuum, confined ...
Artículo
Influence of Temperature on Mechanical Properties of AMCs
(MDPI, 2020-06)
This research focused on studying the effect of temperature on the mechanical properties of aluminium matrix composites (AMCs) obtained by a powder metallurgy route. Aluminium powder was milled at room temperature for 5 h ...
Artículo
Crystallization Process and Microstructural Evolution of Melt Spun Al-RE-Ni-(Cu) Ribbons
(MDPI, 2020-03)
The crystallization process, both at the initial and subsequent stages, of amorphous Al88-RE4-Ni8 alloys (RE = Y, Sm and Ce) has been studied. Additionally, the consequences of adding 1 at.% Cu replacing Ni or Al were ...
Artículo
In Situ Synthesis of Al-Based MMCs Reinforced with AlN by Mechanical Alloying under NH3 Gas
(MDPI, 2018)
Aluminum matrix composites (AMCs) reinforced by aluminum nitride were prepared by mechanical alloying followed by a simple press and sintering method. Milling began under vacuum and after a period of between 1 and 4 h, ...
Artículo
Medium-frequency electrical resistance sintering of oxidized C.P. iron powder
(MDPI, 2018)
Commercially pure (C.P.) iron powders with a deliberate high degree of oxidation were consolidated by medium-frequency electrical resistance sintering (MF-ERS). This is a consolidation technique where pressure, and heat ...
Artículo
A Method to Determine the Electrical Resistance of a Metallic Powder Mass under Compression
(MDPI, 2017-11-06)
In this paper, a phenomenological model to predict the value of the electrical resistance of a compressed metal powder mass is proposed. The model, based on the experimental compressibility and resistivity-porosity curves, ...