Buscar
Mostrando ítems 1-8 de 8
Artículo
Medium-Frequency Electrical Resistance Sintering of Soft Magnetic Powder Metallurgy Iron Parts
(MDPI, 2021-06)
The fabrication of soft magnetic Fe parts by the medium-frequency electrical resistance sintering (MF-ERS) technique is studied in this paper. This consolidation technique involves the simultaneous application to metallic ...
Artículo
Magnetic properties of iron powder sintered by medium-frequency electrical resistance sintering
(Elsevier, 2022)
Medium-frequency electrical resistance sintering (MF-ERS) is a technique that uses the application of pressure and heat, heat coming from the Joule effect, simultaneously to metallic powders. In this study, this technique ...
Artículo
Crystallization Process and Microstructural Evolution of Melt Spun Al-RE-Ni-(Cu) Ribbons
(MDPI, 2020-03)
The crystallization process, both at the initial and subsequent stages, of amorphous Al88-RE4-Ni8 alloys (RE = Y, Sm and Ce) has been studied. Additionally, the consequences of adding 1 at.% Cu replacing Ni or Al were ...
Artículo
Consolidation by MF-ERS of mechanically alloyed Al powder
(Elsevier, 2019-07)
The aim of this work is to study the viability of producing, by medium-frequency electrical resistance sintering (MF-ERS), compacts from mechanically alloyed aluminium powders. The MF-ERS process was carried out using ...
Artículo
In Situ Synthesis of Al-Based MMCs Reinforced with AlN by Mechanical Alloying under NH3 Gas
(MDPI, 2018)
Aluminum matrix composites (AMCs) reinforced by aluminum nitride were prepared by mechanical alloying followed by a simple press and sintering method. Milling began under vacuum and after a period of between 1 and 4 h, ...
Artículo
Medium-frequency electrical resistance sintering of oxidized C.P. iron powder
(MDPI, 2018)
Commercially pure (C.P.) iron powders with a deliberate high degree of oxidation were consolidated by medium-frequency electrical resistance sintering (MF-ERS). This is a consolidation technique where pressure, and heat ...
Artículo
A Method to Determine the Electrical Resistance of a Metallic Powder Mass under Compression
(MDPI, 2017-11-06)
In this paper, a phenomenological model to predict the value of the electrical resistance of a compressed metal powder mass is proposed. The model, based on the experimental compressibility and resistivity-porosity curves, ...
Artículo
Milling amorphous FeSiB ribbons with vibratory ball and disc mills
(Elsevier, 2024-05-15)
Fe, Si and B powders, mixed with atomic composition Fe78Si9B13, are subjected after arc melting to a melt spinning process, which is optimized to obtain the greatest amount of amorphous ribbon. The amorphous ribbons are ...