Buscar
Mostrando ítems 1-8 de 8
Artículo
Effect of high SWNT content on the room temperature mechanical properties of fully dense 3YTZP/SWNT composites
(Elsevier, 2014)
This paper is devoted to correlate the microstructure and room temperature mechanical properties of single-wall carbon nanotube (SWNT) reinforced 3. mol% yttria stabilized tetragonal zirconia with high SWNT content (2.5, ...
Artículo
Hardness and flexural strength of single-walled carbon nanotube/alumina composites
(Kluwer Academic Publishers, 2014)
This work adds new experimental facts on room temperature hardness and flexural strength of alumina and composites with 1, 2, 5 and 10 vol% single-walled carbon nanotubes (SWNT) with similar grain size. Monolithic Al2O3 ...
Artículo
Evidence of nanograin cluster coalescence in spark plasma sintered α-Al2O3
(Elsevier, 2013)
The aim of this study is to elucidate the coarsening kinetics involved during densification of fine-grained pure α-alumina by spark plasma sintering. Low temperature and short dwell time sintering conditions were used to ...
Artículo
Highly efficient electrical discharge machining of yttria-stabilized zirconia ceramics with graphene nanostructures as fillers
(Elsevier, 2022-06-14)
Electrical-discharge machining (EDM) of advanced ceramics allows the miniaturization of parts with complex shapes. Since electrical conductivity is required, non-conductive ceramics need a conductive second phase. This ...
Artículo
Mechanical and electrical properties of low SWNT content 3YTZP composites
(Elsevier, 2015)
Fully dense 3mol% Y2O3-ZrO2 (3YTZP) composites with low single wall carbon nanotube content (0.5, 1 and 1.5vol% SWNT) were prepared by colloidal processing and spark plasma sintering (SPS). SWNT were distributed at ceramic ...
Artículo
R-curve Evaluation of 3YTZP/Graphene Composites by Indirect Compliance Method
(Elsevier, 2023)
This work addresses the crack growth resistance of 3 mol% Yttria-doped Tetragonal Zirconia Polycrystalline (3YTZP) spark-plasma sintered (SPS) composites containing two types of graphene-based nanomaterials (GBN): exfoliated ...
Artículo
Improvement of Vickers hardness measurement on SWNT/Al2O3 composites consolidated by spark plasma sintering
(Elsevier, 2014)
Dense alumina composites with different carbon nanotube content were prepared by colloidal processing and consolidated by Spark Plasma Sintering (SPS). Single-wall carbon nanotubes (SWNTs) were distributed at grain boundaries ...
Artículo
Electrical Performance of Orthotropic and Isotropic 3YTZP Composites with Graphene Fillers
(Elsevier, 2022)
3 mol% yttria tetragonal zirconia polycrystal (3YTZP) composites with orthotropic or isotropic microstructures were obtained incorporating few layer graphene (FLG) or exfoliated graphene nanoplatelets (e-GNP) as fillers. ...