Perfil del autor: Herrada Gutiérrez, Miguel Ángel
Datos institucionales
Nombre | Herrada Gutiérrez, Miguel Ángel |
Departamento | Ingeniería Aeroespacial y Mecánica de Fluidos |
Área de conocimiento | Mecánica de Fluidos |
Categoría profesional | Catedrático de Universidad |
Correo electrónico | Solicitar |
Estadísticas
-
Nº publicaciones
49
-
Nº visitas
5173
-
Nº descargas
7567
Publicaciones |
---|
Trabajo Fin de Grado
Estudio numérico sobre el efecto de surfactantes insolubles en el ascenso de burbujas en tanques infinitos
(2024)
El estudio del comportamiento de las burbujas en medios acuosos es fundamental en diversos campos de la ingeniería, desde ... |
Artículo
The role of charge relaxation in electrified tip streaming
(AIP Publishing, 2023)
We study experimentally and numerically the onset of tip streaming in an electrified droplet. The experiments show that, ... |
Artículo
Global stability analysis of bubbles rising in a vertical capillary with an external flow
(Cambridge University Press, 2023)
We study the linear stability of bubbles in a capillary tube under external flow. Yu et al. (J. Fluid Mech., vol. 911, ... |
Trabajo Fin de Grado
Estudio de la estabilidad global de flujos laminares alrededor de perfiles NACA 2412
(2023)
Una aeronave que vuela en el seno de una corriente de aire moviéndose a una velocidad que forma un ángulo elevado con ... |
Artículo
Effects of geometry in the operation of coaxial electrosprays
(Elsevier, 2023)
Coaxial electrospray is a well established procedure to generate coaxial micro- and nano-structures (microcapsules and ... |
Artículo
Electrokinetic modelling of cone-jet electrosprays
(Cambridge University Express, 2023)
The physics of electrospray has been subject to an intense debate for three decades regarding the ultimate electrokinetics ... |
Trabajo Fin de Grado
Estudio de la estabilidad global de flujos laminares alrededor de perfiles NACA 0012
(2023)
Una aeronave que vuela en el seno de una corriente de aire moviéndose a una velocidad que forma un ángulo elevado con ... |
Tesis Doctoral
Fluid Mechanics for Biomedical Applications: Weakly Viscoelastic Electrospray, Flow Focusing and Collapsible Channel Models
(2022)
Three different research topics are discussed in this thesis: i) weakly-viscoelastic electrospray, ii) the emergence of ... |
Artículo |
Artículo
Global stability analysis of flexible channel flow with a hyperelastic wall
(Cambridge University Press, 2022)
We consider the stability of flux-driven flow through a long planar rigid channel, where a segment of one wall is replaced ... |
Artículo
On the hydrodynamic focusing for producing microemulsions via tip streaming
(Cambridge University Press, 2022)
In this work we study experimentally and numerically the stability of hydrodynamic focusing to produce microemulsions. The ... |
Artículo
Stability and tip streaming of a surfactant-loaded drop in an extensional flow. Influence of surface viscosity
(Cambridge University Press, 2022)
We study numerically the nonlinear stationary states of a droplet covered with an insoluble surfactant in a uniaxial ... |
Artículo
Transonic flow focusing: stability analysis and jet diameter
(Elsevier Ltd, 2021)
We study numerically and experimentally the stability of the transonic flow focusing used in serial femtosecond crystallography ... |
Artículo
Regular and complex singularities of the generalized thin film equation in two dimensions
(Cambridge University Press, 2021)
We use a generalized version of the equation of motion for a thin film of liquid on a solid, horizontal substrate as a ... |
Artículo
Effect of an axial electric field on the breakup of a leaky-dielectric liquid filament
(American Institute of Physics Inc., 2021)
We study experimentally and numerically the thinning of Newtonian leaky-dielectric filaments subjected to an axial electric ... |
Artículo
Infuence of the surface viscous stress on the pinch‑of of free surfaces loaded with nearly‑inviscid surfactants
(Nature Research, 2020)
We analyze the breakup of a pendant water droplet loaded with SDS. The free surface minimum radius measured in the ... |
Artículo
Global stability analysis of axisymmetric liquid-liquid flow focusing
(Cambridge University Press, 2020)
We analyse both numerically and experimentally the stability of the steady jetting tip streaming produced by focusing a ... |
Artículo
Self-similarity in the breakup of very dilute viscoelastic solutions
(Cambridge, 2020)
When pushed out of a syringe, polymer solutions form droplets attached by long and slender cylindrical filaments whose ... |
Artículo
The relationship between viscoelasticity and elasticity
(The Royal Society Publishing, 2020)
Soft materials that are subjected to large deformations exhibit an extremely rich phenomenology, with properties lying in ... |
Tesis Doctoral
Global stability analysis of two-fluid flows
(2019)
The present thesis is a compendium of seven studies devoted to the numerical analysis of nonlinear dynamics and global ... |
Artículo
Development and validation of the terrain stability model for assessing landslide instability during heavy rain infiltration
(Copernicus, 2019)
Slope stability is a key topic, not only for engineers but also for politicians, due to the considerable monetary and human ... |
Artículo
Aerodynamically stabilized Taylor cone jets
(American Physical Society, 2019)
We introduce a way to produce steady micro/nano-liquid jets via electrohydrodynamic elds together with co- owing gas ... |
Ponencia
The natural breakup length of a steady capillary jet
(Bulletin of the American Physical Society, 2019)
Despite their fundamental and applied importance, a general model to predict the natural breakup length of steady capillary ... |
Trabajo Fin de Grado
Estudio, diseño y optimización de un generador de olas
(2019)
En el presente trabajo se aborda el estudio, diseño y optimización de un generador de olas artificiales. En primer lugar, ... |
Artículo
Controlled cavity collapse: scaling laws of drop formation
(Royal Society of Chemistry (RSC), 2018)
The formation of transient cavities at liquid interfaces occurs in an immense variety of natural processes, among which ... |
Artículo
Novel swirl flow‑focusing microfluidic device for the production of monodisperse microbubbles
(Springer, 2018)
A novel swirl flow-focusing microfluidic axisymmetric device for the generation of monodisperse microbubbles at high ... |
Ponencia
Cavity losses estimation in CSP applications
(American Institute of Physics, 2018)
Estimations of convection and radiation cavity losses in two common CSP applications have been analyzed; a cavity in a ... |
Artículo
Viscous Effects on Inertial Drop Formation
(American Physical Society, 2018)
The breakup of low-viscosity droplets like water is a ubiquitous and rich phenomenon. Theory predicts that in the inviscid ... |
Artículo
Column formation and hysteresis in a two-fluid tornado
(Institute of Physics, 2018)
This experimental and numerical study addresses a flow of water and sunflower oil. This flow is driven by the rotating lid ... |
Artículo
Influence of the Surface Viscosity on the Breakup of a Surfactant-Laden Drop
(American Physical Society, 2017)
We examine both theoretically and experimentally the breakup of a pendant drop loaded with an insoluble surfactant. The ... |
Trabajo Fin de Grado
Simulación de chorros capilares compuestos con Ansys
(2017)
Este Trabajo de Fin de Grado trata sobre la generación de gotas con estructura interna controlada a partir de la rotura ... |
Tesis Doctoral
Experimental and Numerical Studies on Microfluidic Systems
(2016)
The work presented in this thesis can be summarized as a compilation of five different and comprehensive studies in the ... |
Trabajo Fin de Grado
Diseño, estudio y fabricación de un sistema Ram-Air para una Moto3
(2016)
El mundo de la competición es un lugar donde cualquier pequeña modificación puede significar la victoria o la derrota. El ... |
Artículo
Electrokinetic effects in the breakup of electrified jets: A Volume-Of-Fluid numerical study
(Elsevier, 2015)
The breakup of a charged liquid column is studied numerically using Volume-OF-Fluid (VOF) for a range of timescales where ... |
Patente. Invención
Método y dispositivo para la producción de micro- y nano-burbujas monodispersas
(Oficina Española de Patentes y Marcas , 2014)
El objeto de esta invención es un método y dispositivos para producir microburbujas de tamaño pequeño y uniforme, utilizando ... |
Patente. Invención
Procedimiento y dispositivo para microfabricación y micro-soldadura
(Oficina Española de Patentes y Marcas (OEPM), 2014)
Dispositivo para microfabricación y micro-soldadura mediante deposición de material en fase líquida (1), que comprende dos ... |
Artículo
Vortex breakdown in a water-spout flow
(AIP Publishing, 2013)
The numerical study of the steady axisymmetric air-water flow in a vertical sealed cylinder, driven by the rotating top ... |
Artículo
Numerical simulation of electrospray in the cone-jet mode
(American Physical Society, 2012)
We present a robust and computationally efficient numerical scheme for simulating steady electrohydrodynamic atomization ... |
Artículo
Enhancement of the stability of the flow focusing technique for low-viscosity liquids
(IOP Publishing, 2012)
We propose a modified flow focusing configuration to produce low-viscosity microjets at much smaller flow rates than those ... |
Patente. Invención
Metodo para la produccion de micro y nano-burbujas monodispersas mediante co-flujo giratorio
(Oficina Española de Patentes y Marcas , 2011)
Método para la producción de micro- y nano-burbujas monodispersas mediante co-flujo giratorio.El objeto de esta invención ... |
Artículo
Generation of small mono-disperse bubbles in axisymmetric T-junction: The role of swirl
(American Institute of Physics Inc., 2011)
The dynamics of micro-bubble formation in an axisymmetric T-junction for a gas-liquid system is analyzed. The approach ... |
Artículo
Experimental and numerical study of the recirculation flow inside a liquid meniscus focused by air
(Springer-Verlag, 2011)
The internal motions inside a liquid meniscus in the so-called liquid cone-jet mode, which can occur upon stimulation by ... |
Artículo
Swirl flow focusing: A novel procedure for the massive production of monodisperse microbubbles
(American Institute of Physics, 2009)
volume-of-fluid numerical method is used to predict the dynamics of microbubble formation in an axisymmetric flow-focusing ... |
Artículo
Liquid flow focused by a gas: Jetting, dripping, and recirculation
(The American Physical Society, 2008)
The liquid cone-jet mode can be produced upon stimulation by a coflowing gas sheath. Most applications deal with the jet ... |
Artículo
Bubbling in Unbounded Coflowing Liquids
(The American Physical Society, 2006)
An investigation of the stability of low density and viscosity fluid jets and spouts in unbounded coflowing liquids is ... |
Patente. Invención
Procedimiento para la fabricación de fibras mediante extrusión con un gas enfocante en régimen subsónico
(Organización Mundial de la Propiedad Intelectual (OMPI), 2005)
El método que se describe en esta invención se aplica a la fabricación de fibras mediante la combinación de dos acciones ... |
Artículo
Nonparallel local spatial stability analysis of pipe entrance swirling flows
(Elsevier, 2004)
A spatial local viscous stability analysis of a swirling flow developing in a cylindrical pipe has been carried out ... |
Artículo
Downstream evolution of unconfined vortices: mechanical and thermal aspects
(Cambridge University Press (CUP), 2002)
We present a numerical study of the downstream evolution (mechanical and thermal) of vortex-jet cores whose velocity and ... |
Tesis Doctoral |