Buscar
Mostrando ítems 1-10 de 19
Artículo
Diseño óptimo de un sistema de inyección convencional con bomba rotativa
(Springer Verlag, 1998)
El presente artículo se ocupa de la aplicación de un modelo de inyección de bomba rotativa al diseño de la misma. En éste se detalla un modelo del sistema de inyección, el cual se ha formado a partir del modelado de las ...
Artículo
Potential of Supercritical Carbon Dioxide Power Cycles to Reduce the Levelised Cost of Electricity of Contemporary Concentrated Solar Power Plants
(MDPI, 2020-07)
This paper provides an assessment of the expected Levelised Cost of Electricity enabled by Concentrated Solar Power plants based on Supercritical Carbon Dioxide (sCO2) technology. A global approach is presented, relying ...
Artículo
Análisis de la dinámica de un grupo motobomba diesel: Implicaciones en las causas de rotura
(Asociación Española de Ingeniería Mecánica, 2004)
En este artículo se analizan las causas de las averías sistemáticas que se producen en un grupo motobomba. Éstas consisten en la rotura de los rotores de la bomba (6 etapas) por la sección de admisión así como del ...
Artículo
Experimental analysis of the effect of hydrogen as the main fuel on the performance and emissions of a modified compression ignition engine with water injection and compression ratio reduction
(Elsevier, 2024-02)
This study aimed to investigate the combined effects of compression ratio (CR), start of injection angle (SOI) and water injection (WI) on the performance, including NOx emissions, of a modified turbocharged compression ...
Artículo
Mechanical analysis of Genoa 03 stirling engine
(International Centre for Sustainable Development of Energy, Water and Environment Systems SDEWES, 2018)
Due to the new technologies development based on renewable sources of energy, in recent years Stirling engines have become very important in the energetic sector. Many of them do not allow the use of fluid lubricants and, ...
Artículo
Heat Transfer Limitations in Supercritical Water Gasification
(MDPI, 2022)
Supercritical water gasification (SCWG) is a promising technology for the valorization of wet biomass with a high-water content, which has attracted increasing interest. Many experimental studies have been carried out ...
Artículo
Thermal Modeling of the Port on a Refining Furnace to Prevent Copper Infiltration and Slag Accretion
(MDPI, 2021-11)
Fire refining of blister copper is a singular process at very high temperatures (~1400 K), which means the furnace is exposed to heavy thermal loads. The charge is directly heated by an internal burner. The impurities in ...
Artículo
Modelo de sobrealimentación para motores de combustión interna alternativos
(Springer Verlag, 2004)
En este trabajo se muestra un modelo mediante el cual se pretende la caracterización del comportamiento e interacción de un grupo de turbosobrealimentación acoplado a un motor de combustión interna alternativo de cuatro ...
Artículo
Preliminary study on the performance of biomorphic silicon carbide as substrate for diesel particulate filters
(VINČA Institute of Nuclear Sciences, 2018)
This paper presents the results of a preliminary experimental study to assess the performance of biomorphic silicon carbide when used for the abatement of soot particles in the exhaust of Diesel engines. Given its optimal ...
Artículo
Estudio de la dinámica del cigüeñal de un motor diesel de 16 cilindros en V a 60º: Implicaciones en las causas de rotura.
(Asociación Española de Ingeniería Mecánica, 2016)
Este artículo analiza las causas de la rotura del cigüeñal de un motor diesel de cuatro tiempos de 16 cilindros en V a 60°, de potencia nominal 1500 k W a 1500 rpm. El análisis se ha desarrollado en tres etapas. En la ...