Buscar
Mostrando ítems 1-10 de 10
Capítulo de Libro
Open-phase fault operation on multiphase induction 3 motor drives
(INTECH Open Science, 2015-11)
Multiphase machines have been recognized in the last few years like an attractive alternative to conventional three-phase ones. This is due to their usefulness in a niche of applications where the reduction in the total ...
Ponencia
Acercamiento a una metodología científica en cursos de energía eólica para ingenieros electrónicos
(Universidad de Sevilla, 2016-06)
La docencia y la investigación son actividades que se realizan de manera simultánea en la práctica universitaria, pero cuya conexión suele ser débil. Mientras que el método científico se basa en etapas bien conocidas, ...
Artículo
IGBT-gating failure effect on a fault-tolerant predictive current-controlled five-phase induction motor drive
(Institute of Electrical and Electronics Engineers (IEEE), 2015)
Multiphase machine drives are gaining importance in high-reliability applications due to their fault-tolerance capability and their ability to cope with the postfault operation without any extra electronic components. ...
Ponencia
A scientific approach in wind energy courses for electrical engineers
(Institute of Electrical and Electronics Engineers, 2016)
Teaching and research are joint activities at University level, but in many cases it is found that both activities have a poor connection. While the scientific method based on well-known steps is commonly applied at ...
Artículo
An Experimental Assessment of Open-Phase Fault- Tolerant Virtual Vector Based Direct Torque Control in Five-Phase Induction Motor Drives
(Institute of Electrical and Electronics Engineers, 2018)
Direct torque control (DTC) has been recently used for the development of high performance five-phase induction motor (IM) drives, where normal operation of the system has been usually considered and the ability of DTC ...
Artículo
Open-Phase Fault-Tolerant Direct Torque Control Technique for Five-Phase Induction Motor Drives
(Institute of Electrical and Electronics Engineers, 2017-02)
Direct torque control (DTC) has been widely used as an alternative to traditional field-oriented control (FOC) methods for three-phase drives. The conventional DTC scheme has been successfully extended to multiphase ...
Artículo
Optimal Fault-Tolerant Control of Six-Phase Induction Motor Drives with Parallel Converters
(Institute of Electrical and Electronics Engineers, 2016)
Multiphase drives and parallel converters have been recently proposed in low-voltage high-power applications. The fault-tolerant capability provided by multiphase drives is then extended with parallel converters, increasing ...
Artículo
Impact of post-fault flux adaptation on six-phase induction motor drives with parallel converters
(IEEE, 2017)
The redundancy of multiphase drives provides an inherent fault-tolerant capability that is appreciated in applications with a complicated corrective maintenance or ...
Capítulo de Libro
Application of DSP in power conversion systems — A practical approach for multiphase drives
(INTECH Open Science, 2015)
Digital Signal Processing is not a recent research field, but has become a powerful technology to solve engineering problems in the last few decades due to the introduction by Texas Instruments in 1982 of the Digital ...
Ponencia
Comparative study of DTC and RFOC methods for the open-phase fault operation of a 5-phase induction motor drive
(Institute of Electrical and Electronics Engineers, 2015)
Direct Torque Control (DTC) technique has been applied in recent times in high performance five-phase induction motor drives during the normal operation of the system. The use of DTC in the multiphase area is far from ...