Buscar
Mostrando ítems 1-10 de 19
Capítulo de Libro
Open-phase fault operation on multiphase induction 3 motor drives
(INTECH Open Science, 2015-11)
Multiphase machines have been recognized in the last few years like an attractive alternative to conventional three-phase ones. This is due to their usefulness in a niche of applications where the reduction in the total ...
Artículo
Model-Based Predictive Current Controllers in Multiphase Drives Dealing with Natural Reduction of Harmonic Distortion
(MDPI, 2019-05)
An important drawback in the application of model-based predictive controllers for multiphase systems is the relatively high harmonic content. Harmonics arise due to the fixed sampling-time nature and the absence of ...
Artículo
IGBT-gating failure effect on a fault-tolerant predictive current-controlled five-phase induction motor drive
(Institute of Electrical and Electronics Engineers (IEEE), 2015)
Multiphase machine drives are gaining importance in high-reliability applications due to their fault-tolerance capability and their ability to cope with the postfault operation without any extra electronic components. ...
Artículo
Interest and Applicability of Meta-Heuristic Algorithms in the Electrical Parameter Identification of Multiphase Machines
(MDPI, 2019-01)
Multiphase machines are complex multi-variable electro-mechanical systems that are receiving special attention from industry due to their better fault tolerance and power-per-phase splitting characteristics compared with ...
Ponencia
A scientific approach in wind energy courses for electrical engineers
(Institute of Electrical and Electronics Engineers, 2016)
Teaching and research are joint activities at University level, but in many cases it is found that both activities have a poor connection. While the scientific method based on well-known steps is commonly applied at ...
Ponencia
Open-Phase Fault Operation of 5-Phase Induction Motor Drives using DTC Techniques
(Institute of Electrical and Electronics Engineers, 2015)
Direct torque control (DTC) is extensively used in conventional three-phase drives as an alternative to field-oriented control methods. The standard DTC technique was originally designed to regulate two independent ...
Artículo
An Experimental Assessment of Open-Phase Fault- Tolerant Virtual Vector Based Direct Torque Control in Five-Phase Induction Motor Drives
(Institute of Electrical and Electronics Engineers, 2018)
Direct torque control (DTC) has been recently used for the development of high performance five-phase induction motor (IM) drives, where normal operation of the system has been usually considered and the ability of DTC ...
Artículo
Open-Phase Fault-Tolerant Direct Torque Control Technique for Five-Phase Induction Motor Drives
(Institute of Electrical and Electronics Engineers, 2017-02)
Direct torque control (DTC) has been widely used as an alternative to traditional field-oriented control (FOC) methods for three-phase drives. The conventional DTC scheme has been successfully extended to multiphase ...
Artículo
Experiencia PBL en una asignatura básica de Electrónica
(Sociedad de Educación del IEEE (IEEE EdSoc), 2012)
The adaptation of the traditional Engineering degrees to the European Higher Education Area creates many challenges in the implementation of recent educational paradigms. This is the case of the Engineering Degree in ...
Ponencia
An open-phase fault detection method for six-phase induction motor drives
(2017-04)
Induction machines (IM) with multiple sets of three-phase windings are a real alternative in safety- critical applications due to their inherent redundancy and extra number of freedom degrees. These properties ...