Listar Artículos (Mecánica de Medios Continuos y Teoría de Estructuras) por agencia financiadora "Universidad de Sevilla"
Mostrando ítems 1-9 de 9
-
Artículo
A new crack-tip element for the logarithmic stress-singularity of Mode-III cracks in spring interfaces
(Springer, 2024-02)A new crack-tip finite element able to improve the accuracy of Finite Element Method (FEM) solutions for cracks growing ...
-
Artículo
Ballast shear effects on the dynamic response of railway bridges
(Elsevier, 2022-12-01)Single-track railway bridges are susceptible of experiencing high levels of vertical acceleration on the deck that may be ...
-
Artículo
Fatigue life of unidirectional 90° carbon/epoxy laminates made of conventional and ultra-thin plies varying manufacturing and testing conditions
(John Wiley & Sons Ltd., 2023)Unidirectional 90° laminates (UD-90) have been tested under tension–tension loading (R = 0.1) to comprehend the effect of ...
-
Artículo
Identification of microplane coefficients to reproduce the behaviour of ultrafine blast-furnace slag binder grout samples
(Springer, 2024-08-17)Ultra-fine blast-furnace slag binders have recently been introduced to repair masonry. The reduced particle diameter of ...
-
Artículo
Influence of Materials of Moulds and Geometry of Specimens on Mechanical Properties of Grouts Based on Ultrafine Hydraulic Binder
(MDPI, 2024-04)Ultrafine hydraulic binder grout injection is a technique utilised for repairing masonry, either to connect sections, seal ...
-
Artículo
Motion-Based Design of Passive Damping Systems to Reduce Wind-Induced Vibrations of Stay Cables under Uncertainty Conditions
(MDPI, 2020-03)Stay cables exhibit both great slenderness and low damping, which make them sensitive to resonant phenomena induced by ...
-
Artículo
Non-conventional failures caused by the edge effect in cross-ply laminates made of ultra-thin plies
(Elsevier, 2023)In a fatigue testing programme of carbon/epoxy cross-ply laminates made of ultra-thin plies, non-conventional failures ...
-
Artículo
Numerical and experimental analysis of ultra-thin plies in carbon/epoxy cross-ply laminates subjected to bending after tensile cyclic loading
(Elsevier, 2023-12)As a result of a fatigue testing campaign in cross-ply laminates with different thicknesses in the 90° ply block (conventional ...
-
Artículo
Thermomechanical characterisation data of 30 g/m2 and 150 g/m2 cured unidirectional carbon/epoxy tape prepreg TP 402/T700S
(Elsevier, 2023)With the aim to calculate through the Classical Laminate Theory the most reliable stress value generated in the 90° layer ...