Buscar
Mostrando ítems 1-5 de 5
Artículo
Effect of stacking direction and raster angle on the fracture properties of Onyx 3D printed components: A mesoscale analysis
(Elsevier, 2024-02)
3D printing is a technology that has gained increasing importance both in academia and industry for the possibilities offered. Among the many, one of the most appealing is the possibility to choose different printing ...
Artículo
Characterization of 3D printed long fibre reinforced composites
(Elsevier, 2018-02)
Additive Layer Manufacturing (ALM) process is used in the present investigation to manufacture long fibre reinforced composite parts using the MarkOne® 3D-printer. In ALM, a continuous filament (including a tow of fibres) ...
Artículo
Accurate determination of the stiffness properties for an elastic interface under peeling conditions between homogeneous materials
(Elsevier, 2022-04)
In this paper, several models for analysing peeling tests are considered, including numerical models based on FEM, semi-analytical approaches, and beam models including an elastic interface. Results show that none of the ...
Artículo
On the 3D extension of failure models for adhesive joints under mixed-mode fracture conditions: LEBIM and CZM
(Elsevier, 2019-04)
Interface models for triggering damage events have been extensively used in many engineering applications due to their inherent versatility and relatively simple numerical implementations. Usually, the non-linear behavior ...
Artículo
A new in situ peeling test for the characterisation of composite bonded joints
(Elsevier, 2018-10)
At the moment, bonded joints quality on composites used in aeronautical industry is verified based on the determination of the interlaminar fracture toughness (Gc) obtained by means of the Double Cantilever Beam (DCB) or ...