Buscar
Mostrando ítems 1-10 de 15
Artículo
A New Method for Determining the Curie Temperature From Magnetocaloric Measurements
(Institute of Electrical and Electronics Engineers, 2016)
A new method is proposed for determining the Curie temperature from magnetocaloric measurements. It is based on the field dependence of the magnetic entropy change close to the Curie temperature. The main advantages over ...
Artículo
Magnetocaloric effect: From materials research to refrigeration devices
(Elsevier, 2018)
The magnetocaloric effect and its most straightforward application, magnetic refrigeration, are topics of current interest due to the potential improvement of energy efficiency of cooling and temperature control systems, ...
Artículo
Influence of Thermal and Magnetic History on Direct DTad Measurements of Ni49+xMn36-xIn15 Heusler Alloys
(MDPI, 2019-10-25)
In the present work, using Heusler Ni49+xMn36-xIn15 (with x = 0 and 0.5) alloys, it is shown that the choice of the appropriate measurement protocol (erasing the prior state of the sample in between experiments) in DTad ...
Artículo
A procedure to extract the magnetocaloric parameters of the single phases from experimental data of a multiphase system.
(AIP Publishing, 2014)
In this work, we propose a method to extract the individual parameters that describe the field dependence of magnetic entropy change of each phase in a multiphase system. This method makes use of the scaling laws of the ...
Artículo
Magnetocaloric response of amorphous and nanocrystalline Cr-containing Vitroperm-type alloys
(Elsevier, 2016)
The broad compositional range in which transition metal (TM) based amorphous alloys can be obtained, yields an easily tunable magnetocaloric effect (MCE) in a wide temperature range. In some TM-based alloys, anomalous ...
Artículo
Analysis of magnetocaloric effect of ball milled amorphous alloys: Demagnetizing factor and Curie temperature distribution
(Elsevier, 2015)
The magnetocaloric effect (MCE) has been measured for an amorphous mechanically alloyed (MA) Co62Nb6Zr2B30. It is demonstrated that sample shape must be taken into account for a correct interpretation of the results, ...
Artículo
Optimal temperature range for determining magnetocaloric magnitudes from heat capacity
(Institute of Physics Publishing, 2016)
The determination of the magnetocaloric magnitudes (specific magnetic entropy change, Δs M, and adiabatic temperature change, ΔT ad) from heat capacity (c H) measurements requires measurements performed at very low ...
Artículo
A quantitative criterion for determining the order of magnetic phase transitions using the magnetocaloric effect
(Nature Publishing Group, 2018)
The ideal magnetocaloric material would lay at the borderline of a first-order and a second-order phase transition. Hence, it is crucial to unambiguously determine the order of phase transitions for both applied magnetocaloric ...
Artículo
Magnetocaloric effect of Co62Nb6Zr2B30 amorphous alloys obtained by mechanical alloying or rapid quenching
(2014)
Amorphous samples of nominal composition Co62Nb6Zr2B30 have been prepared using mechanical alloying (MA) and rapid quenching (RQ) techniques. Differences appear in Curie temperature and the phases developed after ...
Artículo
Nanostructuring as a procedure to control the field dependence of the magnetocaloric effect
(Elsevier, 2017-01)
In this work, the field dependence of the magnetocaloric effect of Gd bulk samples has been enhanced through nanostructuring of the material. Nanostructuring consists in multilayers preparation by alternative rf-sputter ...