Buscar
Mostrando ítems 1-10 de 111
Artículo
Nanocrystalline Fe-Nb-(B,Ge) alloys from ball milling: microstructure, thermal stability and magnetic properties
(Elsevier, 2007)
Fe75B20Nb5, Fe75Ge10B10Nb5 and Fe75Ge20Nb5 alloys were prepared by ball milling from pure powders and their microstructure and magnetic properties were studied. A nanocrystalline solid solution of-Fe type is the main ...
Artículo
Evolution of Fe environments in mechanically alloyed Fe–Nb–(B) compositions
(Elsevier, 2014)
Nanocrystalline alloys of nominal composition Fe85Nb5B10 were produced by mechanical alloying from a mixture of elemental powders. Two commercial boron structures were used: amorphous and crystalline. In addition, a third ...
Artículo
Effect of Thermal Treatments Below Devitrification Temperature on the Magnetic and Magnetocaloric Properties in Mechanically Alloyed Fe70Zr30 Powders
(Elsevier, 2023)
In this work, the relaxation of the amorphous structure of mechanically alloyed Fe70Zr30 powders has been analyzed through interrupted heating ramps below the devitrification temperature. As a result of such thermal ...
Artículo
A Simple Phenomenological Model to Describe Stability of Homogeneous Solid Solutions in High Entropy Alloys from Metallic Bonding Potential
(Elsevier, 2023)
A simple model based on the potential parameters used to describe metallic bonding is extended to solid solu- tions. A figure of merit (an effective temperature, Teff ) is proposed using a simple average over the ...
Artículo
Comparison of equivalent ball milling processes on Fe70Zr30 and Fe70Nb30
(Elsevier, 2012)
Dynamical analysis of the movement of a single ball in a planetary ball mill yields a cubic law with the frequency of the mill for the power released during the process. This fact has been explored for two binary compositions ...
Artículo
Ball milling as a way to produce magnetic and magnetocaloric materials: a review
(Springer Nature, 2017)
Ball milling (BM) is a well-established technique for producing different materials in powder shape. Dynamical analysis of BM helps to optimize the process through simple but general relations (e.g., definition of an ...
Artículo
Analysis of magnetocaloric effect of ball milled amorphous alloys: Demagnetizing factor and Curie temperature distribution
(Elsevier, 2015)
The magnetocaloric effect (MCE) has been measured for an amorphous mechanically alloyed (MA) Co62Nb6Zr2B30. It is demonstrated that sample shape must be taken into account for a correct interpretation of the results, ...
Artículo
Detection of the onset of nanocrystallization by calorimetric and magnetic measurements
(AIP Publishing, 2005-01-24)
It is generally accepted that measurements of the magnetic properties are more sensitive than measurements of the enthalpy changes in the detection of the onset of crystallization of ferromagnetic phases emerging from a ...
Artículo
On the isothermal kinetics analysis of transformations in metastable systems. A combined use of isothermal and non-isothermal calorimetry
(Taylor & Francis, 2007)
A procedure to optimize the isothermal calorimetric data of very slow transformation processes of metastable systems is proposed. The method uses an experimental baseline to identify the transitory effects due to the ...
Artículo
The influence of Co addition on the magnetocaloric effect of Nanoperm-type amorphous alloys
(AIP Publishing, 2006-09-22)
The effect of Co addition on the magnetocaloric effect of amorphous alloys with Nanoperm-type composition has been studied for temperatures above room temperature. Co addition produces an increase in the maximum magnetic ...