Buscar
Mostrando ítems 1-9 de 9
Artículo
A New Method for Determining the Curie Temperature From Magnetocaloric Measurements
(Institute of Electrical and Electronics Engineers, 2016)
A new method is proposed for determining the Curie temperature from magnetocaloric measurements. It is based on the field dependence of the magnetic entropy change close to the Curie temperature. The main advantages over ...
Artículo
Magnetocaloric effect: From materials research to refrigeration devices
(Elsevier, 2018)
The magnetocaloric effect and its most straightforward application, magnetic refrigeration, are topics of current interest due to the potential improvement of energy efficiency of cooling and temperature control systems, ...
Artículo
Anisotropy field distribution in soft magnetic Hitperm alloys submitted to different field annealing processes
(Elsevier, 2016)
The magnetic anisotropy field distribution is discussed for Hitperm alloys annealed under different field conditions leading to different induced magnetic anisotropies: zero (ZF), transversal (TF), and longitudinal (LF) ...
Artículo
Magnetocaloric response of amorphous and nanocrystalline Cr-containing Vitroperm-type alloys
(Elsevier, 2016)
The broad compositional range in which transition metal (TM) based amorphous alloys can be obtained, yields an easily tunable magnetocaloric effect (MCE) in a wide temperature range. In some TM-based alloys, anomalous ...
Artículo
Analysis of magnetocaloric effect of ball milled amorphous alloys: Demagnetizing factor and Curie temperature distribution
(Elsevier, 2015)
The magnetocaloric effect (MCE) has been measured for an amorphous mechanically alloyed (MA) Co62Nb6Zr2B30. It is demonstrated that sample shape must be taken into account for a correct interpretation of the results, ...
Artículo
Optimal temperature range for determining magnetocaloric magnitudes from heat capacity
(Institute of Physics Publishing, 2016)
The determination of the magnetocaloric magnitudes (specific magnetic entropy change, Δs M, and adiabatic temperature change, ΔT ad) from heat capacity (c H) measurements requires measurements performed at very low ...
Artículo
Grinding and particle size selection as a procedure to enhance the magnetocaloric response of La( Fe, Si)(13) bulk samples
(Elsevier, 2017-05)
The magnetocaloric effect of La(Fe,Si)13 samples deteriorates with the presence of secondary phases. However, it is highly challenging to produce single phase samples by conventional procedures and purification requires ...
Artículo
Ball milling as a way to produce magnetic and magnetocaloric materials: a review
(Springer Nature, 2017)
Ball milling (BM) is a well-established technique for producing different materials in powder shape. Dynamical analysis of BM helps to optimize the process through simple but general relations (e.g., definition of an ...
Artículo
Study of Phases Evolution in High-coercive MnAl Powders Obtained Through Short Milling Time of Gas-atomized Particles
(Elsevier, 2017)
Gas-atomized Mn54Al46 particles constituted nominally of only ε- and γ2-phases, i.e. no content of the ferromagnetic L10-type τ-phase, have been used to study the evolution of phases during short time of high-energy milling ...