Ingeniería y Ciencia de los Materiales y del Transporte: Recent submissions
Now showing items 1-20 of 425
-
Article
Design and manufacturing by fused filament technique of novel YSZ porous grafts infiltrated with PCL/PVA/AgNPs for large bone defects repairing
(Elsevier, 2024-02-19)Addressing large bone segmental defects remains a profound challenge in orthopaedic surgery, demanding graft designs that ...
-
Article
Smart Design of ZnFe and ZnFe@Fe Nanoparticles for MRI-Tracked Magnetic Hyperthermia Therapy: Challenging Classical Theories of Nanoparticles Growth and Nanomagnetism
(Wiley, 2024-02)Iron Oxide Nanoparticles (IONPs) hold the potential to exert significant influence on fighting cancer through their ...
-
Article
Improvement of the balance between a reduced stress shielding and bone ingrowth by bioactive coatings onto porous titanium substrates
(Elsevier, 2018-03)Commercial pure titanium is known as good substitute for cortical bone tissue. Nevertheless, stress-shielding and the lack ...
-
Article
Graphene-coated Ti-Nb-Ta-Mn foams: A promising approach towards a suitable biomaterial for bone replacement
(Elsevier, 2020-11)The design of bone implants with proper biological and mechanical properties remains a challenge in medical implantology. ...
-
Article
Understanding the synergetic effects of mechanical milling and hot pressing on bimodal microstructure and tribo-mechanical behavior in porous Ti structures
(Elsevier, 2023-11)The utilization of porous biomedical implants featuring a bimodal microstructure has garnered substantial interest within ...
-
Presentation
Use of Urea and Ammonia to Produce High-Strength PM Aluminium Parts
(European Powder Metallurgy Association (EPMA), 2011)Two methods to obtain bulk nanostructured aluminium parts are compared. The first one consists on milling Al powder in an ...
-
Article
Electrical discharge consolidation of Al and Ti powders
(Elsevier, 2022-07-29)In this paper, electrical-discharge-consolidation (EDC technique) experiments were carried out with an equipment based on ...
-
Article
Amorphous Phase Formation and Heat Treating Evolution in Mechanically Alloyed Ti–Cu Alloy for Biomedical Applications
(Springer, 2022-07-27)The present work aims to produce TixCu100-x (x = 90, 80, 70, and 60) amorphous alloys by using high energy ball mill. The ...
-
Article
Synthesis and characterization of in situ-reinforced Al–AlN composites produced by mechanical alloying
(Elsevier, 2017)This research is focused on the production of aluminum matrix composites (AMCs) reinforced with various percentages of ...
-
Article
Model of dissolution in the framework of tissue engineering and drug delivery
(Springer, 2018-10)Dissolution phenomena are ubiquitously present in biomaterials in many different fields. Despite the advantages of ...
-
Article
PEGylated Terbium-Based Nanorods as Multimodal Bioimaging Contrast Agents
(American Chemical Society, 2021)Diagnostic imaging strongly relies on the use of contrast agents (CAs). In general terms, current CAs present undesirable ...
-
Article
Development of electric resistance sintering process for the fabrication of hard metals: Processing, microstructure and mechanical properties
(Elsevier, 2017)This work presents the development of the Electrical Resistance Sintering (ERS) process for the fabrication of hard metals. ...
-
Article
Crystallisation of amorphous Al-Y-Ni-(Cu)alloys
(Elsevier, 2019)The nanocrystallisation behaviour and subsequent intermetallics formation of an amorphous Al88-Y4-Ni8 alloy has been ...
-
Article
Investigation of catalytic activation of peroxydisulfate on cu-doped mesoporous silica-based particles (Cu-BMS) for efficient degradation of methylene blue
(Elsevier, 2024-01)The Cu-doped mesoporous silica-based particles (Cu-BMS) were prepared using an evaporation-induced self-assembly sol-gel ...
-
Chapter of Book
Determinación de diagramas de fases a partir de las curvas de energía libre-composición
(Universidad de Sevilla, 2020) -
Article
Aprendizaje basado en proyectos en el grado de Educación Primaria: trabajar por proyectos para aprender a trabajar por proyectos
(Centro de Estudios Universitarios Cardenal Espínola, CEU, 2021)Se presenta en este trabajo un proyecto interdisciplinar de innovación fundamentado en la me-todología del Aprendizaje ...
- Chapter of Book
-
Chapter of Book
El acero valyrio, desde la fantasía y la ciencia ficción
(Dykinson, 2023) -
Article
Sol–gel derived B₂O₃–CaO borate bioactive glasses with hemostatic, antibacterial and pro-angiogenic activities
(Oxford University Press and Chinese Society for Biomaterials, 2023-11)Sol–gel borate bioactive glasses (BGs) are promising ion-releasing biomaterials for wound healing applications. Here, we ...
-
Article
On the Modernisation of Weber’s Electrodynamics
(MDPI, 2023-04-25)This work is an attempt to modernise Weber’s electrodynamics to make it compatible with the high-velocity regime, and with ...