Física de la Materia Condensada
Collections in this community
Recent Submissions
-
Article
Additive manufacturing of magnetocaloric (La,Ce)(Fe,Mn,Si)13–H particles via polymer-based composite filaments
(Elsevier, 2022-11)Additive manufacturing could be an excellent way of shaping magnetocaloric heat exchangers in magnetic refrigerators. ...
-
Article
Huso horario, cambio estacional de hora y horarios en España
(Real Sociedad Española de Física, 2024-02-19)Se analiza el problema de los horarios y la hora legal en España.
-
Article
Changing the clocks: Latitudes and attitudes
(American Institute of Physics, 2024-02-01) -
Article
Dry Eye Para-Inflammation Treatment: Evaluation of a Novel Tear Substitute Containing Hyaluronic Acid and Low-Dose Hydrocortisone
(MDPI, 2023)Purpose: The purpose of this study was to check the efficacy and safety of a novel tear substitute containing hyaluronic ...
-
Article
Boots in summer vs sandals in winter? The dilemma that makes cancelling daylight saving time tricky
(Springer, 2024-01-31)A short take on the pros and cons associated with daylight saving time
-
Article
Daylight-saving time is a solution for which many forgot the problems
(American Academy of Sleep Medicine (AASM), 2024-01-19)Se describe la utilidad del cambio de hora
-
Article
Creep properties of high dense La9.33Si6O26 electrolyte for SOFCs
(Elsevier, 2020-05)High density La9.33Si6O26 polycrystals were fabricated by conventional and spark plasma sintering starting from nanopowders ...
-
Article
High-temperature mechanical behavior of proton-conducting yttrium-doped barium zirconate perovskite
(Elsevier, 2021-02)The high-temperature mechanical properties of yttrium doped barium zirconate obtained by two different routes are reported ...
-
Article
Fabrication and creep properties of eutectic-composition Al2O3/YAG/YSZ sintered composites
(Elsevier, 2021-12)Three-phase alumina/YAG/yttria-stabilized cubic zirconia (YSZ) composites were fabricated by a solid-state reaction route ...
-
Article
Dynamic recrystallization during creep of proton-conducting barium cerate perovskites
(Wiley-Blackwell, 2022-11)Uniaxial compression tests were conducted on perovskite-structured barium cerate polycrystals doped with 5-at.% yttrium ...
-
Article
High-temperature plastic behavior of TZP-Ni cermets
(Wiley-Blackwell, 2008-02)The creep behavior of tetragonal zirconia TZP-Ni cermets with metal contents below, close to, and above the percolation ...
-
Article
Anomalous high activation energy for creep in nanostructured 3YTZP/Ni cermets
(Elsevier, 2007)The plastic behavior of cermets based on a 3 mol% yttria-stabilized tetragonal zirconia matrix that incorporates nanometric ...
-
Article
Microstructural characteristics of TZP/Ni cermets plastically deformed at high temperature
(Elsevier, 2007)The microstructure of 3 mol% Y2O3-stabilized tetragonal ZrO2/Ni (TZP/Ni) composites has been investigated for nickel ...
-
Article
Influence of oxidation on the high-temperature mechanical properties of zirconia/nickel cermets
(Elsevier, 2006-06)The influence of an oxidizing atmosphere on the high-temperature plasticity of zirconia/nickel cermets has been studied ...
-
Article
Influence of the processing route on the carbon nanotubes dispersion and creep resistance of 3YTZP/SWCNTs nanocomposites
(Wiley-Blackwell, 2015-02-01)3YTZP matrix composites containing 2.5 vol% of single-walled carbon nanotubes (SWCNT) were fabricated by Spark Plasma ...
-
Article
Optimizing the homogenization technique for graphene nanoplatelet/yttria tetragonal zirconia composites: Influence on the microstructure and the electrical conductivity
(Elsevier, 2018-10-30)3 mol% yttria tetragonal zirconia polycrystalline (3YTZP) ceramic composite powders with 10 vol% nominal content of graphene ...
-
Article
Evolution of number of citations per article in Materials Science: possible causes and effect on the impact factor of journals
(Springer, 2023-11)An overall rise in the citation parameters used in the metrics of scientifc publications (i.e. journal impact factor, ...
-
Article
Mechanical Alloying as a Way to Produce Metastable Single-Phase High-Entropy Alloys beyond the Stability Criteria
(MDPI, 2023-12)Various stability criteria developed for high-entropy alloys are applied to compositions produced by mechanical alloying. ...
-
Article
Instantaneous growth approximation describing the nanocrystallization process of amorphous alloys: A cellular automata model
(Elsevier, 2008-07)A cellular automata simulation based on an instantaneous growth approximation is developed to model the nanocrystallization ...
-
Article
Grinding and particle size selection as a procedure to enhance the magnetocaloric response of La( Fe, Si)(13) bulk samples
(Elsevier, 2017-05)The magnetocaloric effect of La(Fe,Si)13 samples deteriorates with the presence of secondary phases. However, it is highly ...