Artículo
Influence of the processing route on the carbon nanotubes dispersion and creep resistance of 3YTZP/SWCNTs nanocomposites
Autor/es | Castillo Rodríguez, Miguel
Muñoz Bernabé, Antonio Morales Rodríguez, Ana Poyato Galán, Rosalía Gallardo López, Ángela María Domínguez Rodríguez, Arturo |
Departamento | Universidad de Sevilla. Departamento de Física de la Materia Condensada |
Fecha de publicación | 2015-02-01 |
Fecha de depósito | 2024-01-10 |
Publicado en |
|
Resumen | 3YTZP matrix composites containing 2.5 vol% of single-walled carbon nanotubes (SWCNT) were fabricated by Spark Plasma Sintering (SPS) at 1250C, following different processing routines with the aim of optimizing the SWCNTs ... 3YTZP matrix composites containing 2.5 vol% of single-walled carbon nanotubes (SWCNT) were fabricated by Spark Plasma Sintering (SPS) at 1250C, following different processing routines with the aim of optimizing the SWCNTs dispersion throughout the ceramic matrix. Microstructural characterization of the as-fabricated samples has been performed by means of scanning electron microscopy (SEM). The specimens have been crept at 1200C to correlate creep resistance and SWCNTs distribution. There are no creep experimental results on these nanocomposites reported in literature. Mechanical results show that the incorporation of SWCNTs into a 3YTZP matrix produces an increase in the strain rate at high temperature with respect to monolithic zirconia. The creep resistance of these nanocomposites decreases with the improvement of the SWCNTs dispersion, where a smaller SWCNTs agglomerate size and consequently a higher concentration of carbon nanotubes surrounding the 3YTZP grain boundaries is found. This fact indicates that SWCNTs act as a lubricant making grain-boundary sliding easier during deformation of these composites. |
Agencias financiadoras | Ministerio de Economía y Competitividad (MINECO). España Junta de Andalucía |
Identificador del proyecto | MAT2009-11078
MAT2012-34217 P12-FQM-1079 |
Cita | Castillo Rodríguez, M., Muñoz Bernabé, A., Morales Rodríguez, A., Poyato Galán, R., Gallardo López, Á.M. y Domínguez Rodríguez, A. (2015). Influence of the processing route on the carbon nanotubes dispersion and creep resistance of 3YTZP/SWCNTs nanocomposites. Journal of the American Ceramic Society, 98 (2), 645-653. https://doi.org/10.1111/jace.13348. |
Ficheros | Tamaño | Formato | Ver | Descripción |
---|---|---|---|---|
Influence of the processing.pdf | 1.051Mb | [PDF] | Ver/ | Versión aceptada |