Buscar
Mostrando ítems 1-10 de 14
Artículo
High-temperature mechanical behavior of proton-conducting yttrium-doped barium zirconate perovskite
(Elsevier, 2021-02)
The high-temperature mechanical properties of yttrium doped barium zirconate obtained by two different routes are reported in this work. Polycrystals with composition BaZr0.85Y0.15O2.925 have been fabricated from nanopowders ...
Artículo
The Possible Detriment of Oxygen in Creep of Alumina and Zirconia Ceramic Composites Reinforced with Graphene
(MDPI, 2021)
This paper aims to give an answer to the following question: is the oxidation of graphene a critical issue for high-temperature plasticity in graphene-reinforced ceramics? To give a convincing reply, we will focus on two ...
Artículo
Unravelling the optimization of few-layer graphene crystallinity and electrical conductivity in ceramic composites by Raman spectroscopy
(Elsevier, 2021)
Zirconia composites with few-layer graphene (FLG) were prepared by two powder processing routines -ultrasonic agitation or planetary ball milling- and spark plasma sintered at 1250 and 1300 °C. An in-depth study of the ...
Artículo
Ageing-resistant zirconia/graphene-based nanostructures composites for use as biomaterials
(Elsevier, 2022)
This work explores the incorporation of graphene-based two-dimensional nanostructures as moisture barriers to delay hydrothermal ageing of yttria-stabilized zirconia and strengthen its use in biomedical applications. Two ...
Artículo
Enhancing the electrical conductivity of in-situ reduced graphene oxide-zirconia composites through the control of the processing routine
(Elsevier, 2021)
Graphene oxide (GO) was mixed with 3 mol% yttria tetragonal zirconia polycrystal (3YTZP) using two powder processing routines: a colloidal method in an aqueous solution and a combination of ultrasonication with high-energy ...
Artículo
Critical Influence of the Processing Route on the Mechanical Properties of Zirconia Composites with Graphene Nanoplatelets
(MDPI, 2021)
Graphene-based nanostructures, used as potential reinforcement in ceramic composites, have a great tendency to agglomerate. This requires the use of homogenization techniques during the powder processing, posing the need ...
Artículo
One-reactor vacuum and plasma synthesis of transparent conducting oxide nanotubes and nanotrees: from single wire conductivity to ultra-broadband perfect absorbers in the NIR
(Royal Society of Chemistry, 2021)
The eventual exploitation of one-dimensional nanomaterials needs the development of scalable, high yield, homogeneous and environmentally friendly methods capable of meeting the requirements for fabrication of functional ...
Artículo
Premelting of ice adsorbed on a rock surface
(Royal Society of Chemistry, 2020-05-28)
Considering ice-premelting on a quartz rock surface (i.e. silica) we calculate the Lifshitz excess pressures in a four layer system with rock-ice-water-air. Our calculations give excess pressures across (1) ice layer, (2) ...
Artículo
R-curve Evaluation of 3YTZP/Graphene Composites by Indirect Compliance Method
(Elsevier, 2023)
This work addresses the crack growth resistance of 3 mol% Yttria-doped Tetragonal Zirconia Polycrystalline (3YTZP) spark-plasma sintered (SPS) composites containing two types of graphene-based nanomaterials (GBN): exfoliated ...
Artículo
Mechanical properties of ceramics reinforced with allotropic forms of carbon
(Elsevier, 2022)
For decades, enormous investigation effort has been devoted to the fabrication of new ceramic matrix composites with enhanced mechanical properties. One of the most explored strategies is the addition of carbon allotropic ...