Buscar
Mostrando ítems 1-7 de 7
Artículo
Effect of high SWNT content on the room temperature mechanical properties of fully dense 3YTZP/SWNT composites
(Elsevier, 2014)
This paper is devoted to correlate the microstructure and room temperature mechanical properties of single-wall carbon nanotube (SWNT) reinforced 3. mol% yttria stabilized tetragonal zirconia with high SWNT content (2.5, ...
Artículo
Hardness and flexural strength of single-walled carbon nanotube/alumina composites
(Kluwer Academic Publishers, 2014)
This work adds new experimental facts on room temperature hardness and flexural strength of alumina and composites with 1, 2, 5 and 10 vol% single-walled carbon nanotubes (SWNT) with similar grain size. Monolithic Al2O3 ...
Artículo
Deformation mechanisms in yttria-stabilized cubic zirconia single crystals
(Walter de Gruyter, 2010)
This work attempts to give a unified picture of the microscopic mechanisms which control the plastic deformation in yttria-stabilized cubic zirconia single crystals, particularly for the soft orientation (uniaxial compression ...
Artículo
Mechanical and electrical properties of low SWNT content 3YTZP composites
(Elsevier, 2015)
Fully dense 3mol% Y2O3-ZrO2 (3YTZP) composites with low single wall carbon nanotube content (0.5, 1 and 1.5vol% SWNT) were prepared by colloidal processing and spark plasma sintering (SPS). SWNT were distributed at ceramic ...
Artículo
Improvement of Vickers hardness measurement on SWNT/Al2O3 composites consolidated by spark plasma sintering
(Elsevier, 2014)
Dense alumina composites with different carbon nanotube content were prepared by colloidal processing and consolidated by Spark Plasma Sintering (SPS). Single-wall carbon nanotubes (SWNTs) were distributed at grain boundaries ...
Artículo
Influence of the processing route on the carbon nanotubes dispersion and creep resistance of 3YTZP/SWCNTs nanocomposites
(Wiley-Blackwell, 2015-02-01)
3YTZP matrix composites containing 2.5 vol% of single-walled carbon nanotubes (SWCNT) were fabricated by Spark Plasma Sintering (SPS) at 1250C, following different processing routines with the aim of optimizing the SWCNTs ...
Artículo
Creep behavior of TiCxN1-x-CoTi cermets synthesized by mechanically induced self-sustaining reaction
(Elsevier, 2011-03)
The plastic flow of TiCxN1−x–CoTi cermets has been investigated by uniaxial compression tests carried out in argon atmosphere at temperatures between 1100 and 1200 ◦C. Two different cermets, with 5 wt.% W or WC content ...