Perales Esteve, Manuel Ángel2024-09-272024-09-272024Sotelo Castillo, D. (2024). Diseño y realización de un interfaz MIDI sobre Formato de Publicación de la Escuela Técnica Superior de Ingeniería USB con multiplexión de entradas. (Trabajo Fin de Máster Inédito). Universidad de Sevilla, Sevilla.https://hdl.handle.net/11441/163022Este Trabajo Fin de Máster se centra en el desarrollo de un dispositivo denominado "MIDI Funnel". El principal objetivo de este dispositivo es facilitar la comunicación entre diferentes implementaciones del protocolo MIDI, permitiendo mantener la compatibilidad de los sistemas MIDI más tradicionales que usan conexiones DIN de 5 pines con dispositivos modernos que utilizan USB. El proyecto se estructura en varias fases, comenzando con una investigación exhaustiva sobre el estándar MIDI y la comunicación MIDI-over-USB. Esta fase inicial proporciona el contexto necesario y justifica la relevancia del proyecto tras un estudio de mercado. Posteriormente, se detallan las herramientas de hardware y software utilizadas durante el transcurso del proyecto, justificando su necesidad y elección frente a otras alternativas. Unapartecrucial del trabajo es el desarrollo del hardware necesario, que incluye el diseño de circuitos MIDI IN y MIDI OUT, un host USB y la integración de una pantalla táctil, todo implementado en una misma PCB. Además, se desarrolla una aplicación que gestiona la comunicación y el control del dispositivo, permitiendo la configuración y operación del MIDI Funnel mediante una interfaz gráfica. Los experimentos realizados validan el funcionamiento del dispositivo en diferentes escenarios. Los resultados de estos experimentos demuestran la efectividad y eficiencia del dispositivo, cumpliendo con los objetivos planteados al inicio del proyecto.This Master’s Thesis focuses on the development of a device called "MIDI Funnel". The main objective of this device is to facilitate communication between different implementa tions of the MIDI protocol, allowing the compatibility of traditional MIDI systems that use 5-pin DIN connections with modern devices that use USB. The project is structured in several phases, beginning with an exhaustive investigation of the MIDI standard and MIDI-over-USB communication. This initial phase provides the necessary context and justifies the relevance of the project following a market study. Subsequently, the hardwareandsoftwaretoolsusedduringtheprojectaredetailed,justifying their necessity and why they were selected over other alternatives. Acrucial part of the work is the development of the necessary hardware, which includes the design of MIDI IN and MIDI OUT circuits, a USB host, and the integration of a touchs creen, all of this implemented into a single PCB. In addition, an application is developed to manage the communication and control of the device, allowing the configuration and operation of the MIDI Funnel through a visual interface. The experiments conducted validate the device’s functionality in different scenarios. The results of these experiments demonstrate the effectiveness and efficiency of the device, meeting the objectives set at the beginning of the project.application/pdf87 p.spaAttribution-NonCommercial-NoDerivatives 4.0 Internacionalhttp://creativecommons.org/licenses/by-nc-nd/4.0/Diseño y realización de un interfaz MIDI sobre Formato de Publicación de la Escuela Técnica Superior de Ingeniería USB con multiplexión de entradasinfo:eu-repo/semantics/masterThesisinfo:eu-repo/semantics/openAccess