Buscar
Mostrando ítems 1-7 de 7
Artículo
Rietveld analysis and mechanical properties of in situ formed La-β-Al2O3/Al2O3 composites prepared by sol-gel method
(Elsevier, 2022)
In this work, the crystal evolution of α-Al2O3 composites reinforced with LBA platelets were monitored by XRD Rietveld. In addition, the mechanical properties of totally densified specimens were researched by Vickers ...
Artículo
Fabrication and creep properties of eutectic-composition Al2O3/YAG/YSZ sintered composites
(Elsevier, 2021-12)
Three-phase alumina/YAG/yttria-stabilized cubic zirconia (YSZ) composites were fabricated by a solid-state reaction route starting from commercial powders of Al2O3, Y2O3 and monoclinic ZrO2. The final phases Al2O3, YAG and ...
Artículo
Hardness and flexural strength of single-walled carbon nanotube/alumina composites
(Kluwer Academic Publishers, 2014)
This work adds new experimental facts on room temperature hardness and flexural strength of alumina and composites with 1, 2, 5 and 10 vol% single-walled carbon nanotubes (SWNT) with similar grain size. Monolithic Al2O3 ...
Artículo
Evidence of nanograin cluster coalescence in spark plasma sintered α-Al2O3
(Elsevier, 2013)
The aim of this study is to elucidate the coarsening kinetics involved during densification of fine-grained pure α-alumina by spark plasma sintering. Low temperature and short dwell time sintering conditions were used to ...
Artículo
Creep study on alumina and alumina/SWCNT nanocomposites
(Elsevier, 2018)
Alumina and alumina/SWCNT nanocomposites have been sintered by spark plasma sintering, obtaining relative densities higher than 99%. Microstuctural characterization revealed a grain microstructure in the submicron range, ...
Artículo
Improvement of Vickers hardness measurement on SWNT/Al2O3 composites consolidated by spark plasma sintering
(Elsevier, 2014)
Dense alumina composites with different carbon nanotube content were prepared by colloidal processing and consolidated by Spark Plasma Sintering (SPS). Single-wall carbon nanotubes (SWNTs) were distributed at grain boundaries ...
Artículo
Estudio comparativo de técnicas de preparación de muestras para microscopía electrónica de transmisión de recubrimientos cerámicos proyectados por plasma
(2000)
El desarrollo de materiales avanzados, con microestructuras cada vez más complejas, supone un reto constante de desarrollo y aplicación de técnicas que permitan el análisis de la microestructura de forma eficiente. En el ...